UK Club bulletin warns on dangers of pressing up ballast tanks

The UK P&I Club has issued a loss prevention bulletin on the dangers of pressing up ballast tanks.

In a recent case, says the bulletin, an entered vessel pressed up its ballast tanks in order to optimize trim and to satisfy mandatory stability criteria. The operation resulted in the unexpected flooding of a cargo hold causing extensive damage to cargo. 

The containership was carrying out ballast exchange operations mid voyage and pressed up one set of double bottom ballast tanks. On arrival it was observed that one of the holds had significant water inside and considerable damage to bottom stow cargo. 

The vessel had recently opened up several manhole covers for routine inspection of her ballast tanks.

After the incident it was noted that the high level bilge alarms in the hold were not functioning.

The bulletin says that investigations are still continuing into this particular case but says it “maybe timely to remind Members that poorly secured manhole covers are still a frequent cause of water ingress into holds, many, but not all, arising after drydocking where shore staff have not secured covers properly.”

• If double bottom manhole covers are removed for whatever purpose it is recommended a note be made of where and when, this not only acts as an aide memoire but also helps in defending  claims should water ingress occur
• Good maintenance should also be in place, the manhole covers/gasket arrangement and like should be routinely checked, if not already included as part of the routine inspection / maintenance program associated with the ship’s ballast tanks 
• Hold high level bilge alarms should be tested on a regular basis, logged and defects, if any, rectified immediately. 

Source: UK P&I Club

March 16, 2012